I have more than a cars worth of rear upper air intake inserts for a 412 wagon. Price is $55 shipped for all in the USA. Thanks, Jason
Ford 5.0, 302, V8, High Output HO Upper Lower Intake with Complete Engine Harness, Fuel Rails, 8 Fuel Injectors, Cam Shaft and oil cooler. Cleaning out garage, Can deliver depending on Distance. Ford, 5.0, 302, Mustang, Explorer, F150,
97 ford explorer upper efi manifold. This intake will fit small block ford 5.0L base engines. I have only the black one left Asking $45.00 call anytime.
Upper Intake Manifold from Chrysler 300 with Hemi 5.7.
Upper and lower intake manifold for a 99-04 Ford 3.8l v6 came out of a 99 mustang $50 for the pair or $75 if you would like the Accel performance coil to come with it. Great for a performance increase on a sn95 v6 mustang
Upper and lower intake manifolds pulled from a running 351w bronco $50 for the pair or $75 if you would like the throttle body included Wich has fairly new tps and iac
Have a complete 89 Mustange HO Intake upper ,lower,wiring harness,and fuel rails with injectors and throttle body. This was the HO roller motor they had in 89.Also have the roller lifters , cam ,and nice crank for the same engine. We stroked the original engine and couldnt use the stock parts . Was a running engine before being stroked . A little dirty from sitting on shelves but in nice used c...
Used ToyotaLexus upper intake plenum for 3.5L v6 with throttle body. This came off an engine out of a Toyota Sienna, but will work on any Toyota or Lexus 3.5L v6 engine. It is in very good condition, and has absolutely no damage. It does have the gaskets in it, but I would recommend replacing the gaskets when installing, its too much work to take it back off to replace some pretty cheap gaskets...
All parts from 92 Mustang Edelbrock Performer RPM lowerpolished upper intake $525, and BBK 70mm EGR plate $55Lower intake has a threaded insert. There was a crack around the threaded insert that was repaired at the local welding shop. See photo
I have just about any type of intake spacer you might need some phenolic and some aluminum. Selling-off all of my car parts. Let me know which manifold and how thick of a spacer you need, and I will reply with photos. I only have spacers that fit the 86-93 5.0 engines. $50 for each spacer.